How to install the reducer gear

‌1. Preparation‌:

First, check whether the reducer box is clean and dry, and there must be no impurities or dust. Make sure that the gears inside the reducer mesh well when installed in the box, and there is no jamming. ‌

2. Installation steps‌:

● Install the key on the motor shaft.

● Install the input gear on the motor shaft, and make sure that there is no foreign matter stuck on the mounting surface to avoid affecting the installation accuracy and causing abnormal noise, vibration and other problems. ‌

● Use hexagon socket bolts to tighten the input gear and motor shaft, and use screw fasteners to prevent loosening.

● Insulate the reducer to ensure that the electrical connection between the motor and the reducer is good.

‌3. Precautions‌:

Make sure that the meshing surface of the gear is clean and free of impurities and burrs to avoid damage to the gear or bearing.

When installing, pay attention to the position and forward and reverse directions of the gears to ensure smooth transmission.

After installation, operation debugging should be carried out to ensure that the reducer can work normally.

During use, the operating condition of the reducer should be checked regularly, and worn or damaged parts should be replaced in time.

‌4. Debugging and maintenance‌:

After installation, check whether there are any debris around the reducer to ensure that the reducer is firmly fixed without vibration and noise. Check the operating condition of the reducer regularly, and maintain and replace worn parts in time.

Through the above steps and precautions, you can ensure that the reducer gears are installed correctly, the transmission is smooth, the lubrication is good, and there is no noise or vibration.